Pump included at the brass ball valve discharge line. After achieving full pressure latch gradually open up. If when starting the pump unit in the water will be an admixture of sand or clay particles, it is necessary to reduce water consumption by adjusting the valve on the discharge of his plumbing pipeline. Suspend the operation of the Taco bronze pump in this case you can not avoid the deposition of rock particles in his air-supply side. The pump can be stopped if he shakes clean water. In this case, the motor shut down after closing the valve on the discharge plumbing pipeline, as the pump after the (non-return valve) while rotating in the opposite direction. Therefore, the pump can be re-enabled only after the water level in the plumbing pipeline and well and not less than 5 minutes after shutdown.
When you turn on the universal switch rotor motor is not cranked, check all electrical installation diagram, the voltage in all three phases and its value. Never run the installation of an electric motor which is not flooded with water. After starting the Taco 007 pump installation check the water pressure gauge and set the direction of rotation of the pump (in the right direction pump delivers more pressure).
