Aluminum Radiators – elegant, light, high heat transfer – are the most popular on the USA market. Aluminum radiators around 50% of heat through radiation give, the rest – with the help of convection. Thus, these heaters are the most efficient source of heat in the room. Using a highly developed surface in the form of additional thin fins (fin), placed inside the section, increases the effective area of heat removal of up to 0.5 m, which increases the heat sink. Due to the small volume of water in sections, aluminum radiators respond well to management by Honeywell thermocouples. The thermal inertia of the heat sink is not large, and changes in the thermostatic mixing valve will be seen within 7-10 minutes. It is possible to achieve savings of thermal resources by 20-30%.
Kickspace Heaters have a maximum heat transfer – due to its high thermal conductivity of aluminum. When combined with optimal price they offer excellent competitive market radiators. But not without its drawbacks – the various chemical reactions inside walls of the Kickspace heater with alkaline or acidic coolants central heating systems. The family of Beacon Morris Kickspace Heaters all heaters are more multi-stage anti-corrosion protection, which significantly reduces the corrosion rate. The length of the radiator (and thus their power) can easily pick up by changing the number of sections used. Given the wide range of center distance of 350 mm and 500 can always find a configuration that meets the various architectural features of the room (the width of openings, piers, the height of the niches deep window sills, etc.). Each section has an upper and lower reservoirs, connected by a vertical channel, and fins, which increases heat transfer. Most of these radiators are made in Italy, where the design is of special value, so you can fit the model, which looks well fit into any interior, modern technology can produce aluminum products of almost any design, because of its successful thermal properties. Kickspace Heaters are subject to corrosion, since copper fairly active metal. Situation normalizes oxide film that forms on the copper surface and is not chemically active, as well as additional anti-corrosion preparation heater, which is used by some manufacturers.
- optimal price
- high heat
- large area of the cross-section tubes
- elegant design
- light weight sections
- high pressure 18 atmosphere
- Possible corrosion in low-quality coolant in central heating systems
- There is a need to remove air from the upper reservoir through thermostatic valve. In the case of total devastation is recommended to disable the system using the mixing valves and fittings to prevent corrosion of internal surfaces. After this, be sure to open the air vent valve.